Hyundai Venue (QX): Heated Oxygen Sensor (HO2S) / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) / Repair procedures

Inspection
Wave form
1.
Check signal waveform of HO2S using a diagnostic tool.
Specification : Refer to "Waveform"
Heater Resistance
1.
Turn the ignition switch OFF.
2.
Disconnect the knock sensor connector.
3.
Measure resistance between HO2S heater terminals 3 and 4.
4.
Check that the resistance is within the specification.
Specification : Approximately 3.0Ω [20°C (68°F)]
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the connector (A), and then remove the sensor (B).
Heated oxygen sensor installation :
39.2 - 49.1 N.m (4.0 - 5.0 kgf.m, 28.9 - 36.2 lb-ft)
Hyundai Venue. Repair procedures   
•
Note that the SST (Part No.: 09392-1Y100 or 09392-2H100) is useful when removing the heated oxygen sensor.
[Bank 1 / Sensor 1]

Hyundai Venue. Repair procedures

Hyundai Venue. Repair procedures

[Bank 1 / Sensor 2]

Hyundai Venue. Repair procedures

Hyundai Venue. Repair procedures
Installation
Hyundai Venue. Repair procedures   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Hyundai Venue. Repair procedures   
•
DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.
•
Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).
1.
Install in the reverse order of removal.

    Circuit Diagram [M/T] [A/T] Harness Connector [Bank 1 / Sensor 1] [Bank 1 / Sensor 2]

    Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Photo Sensor. Description and operation

    Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received which is transferred to th

    Hyundai Venue (QX) (2020-2026) Service Manual: Evaporator Core. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 3. Separate the evaporator temperature sensor connector (A), loosen the mounting screws and remove the eva

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0189