Hyundai Venue (QX): ETC (Electronic Throttle control) System / Schematic diagrams

Schematic Diagram

Hyundai Venue. Schematic diagrams

Circuit Diagram
[M/T]

Hyundai Venue. Schematic diagrams

[A/T]

Hyundai Venue. Schematic diagrams

Harness Connector

Hyundai Venue. Schematic diagrams

    Fail-safe Mode Items Fail-safe ETC Motor Throttle valve stuck at 5° TPS TPS 1 fault Replace it with TPS2 TPS 2 fault Replace it with TPS1 TPS 1, 2 fault Throttle valve stuck at 5° APS APS 1 fault Replace it with APS2 APS 2 fault Replace it with APS1 APS 1, 2 fault Throttle valve stuck at 5°    • When throttle value is stuck at 5°, engine speed is limited at below 1,500 rpm and vehicle speed at maximum 40 - 50 km/h (25 - 31mph).

    Inspection Throttle Position Sensor (TPS) 1. Connect a diagnostic tool on the Data Link Connector (DLC). 2.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Condenser. Repair procedures

    Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station. 3. When the engine is cool, drain the engine coolant from the radiator.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0118