Hyundai Venue (QX): ETC (Electronic Throttle control) System / Troubleshooting

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle control) System / Troubleshooting

Fail-safe Mode
Items
Fail-safe
ETC Motor
 Throttle valve stuck at 5°
TPS
 TPS 1 fault
 Replace it with TPS2
TPS 2 fault
 Replace it with TPS1
TPS 1, 2 fault
 Throttle valve stuck at 5°
APS
 APS 1 fault
 Replace it with APS2
APS 2 fault
 Replace it with APS1
APS 1, 2 fault
 Throttle valve stuck at 5°

Hyundai Venue. Troubleshooting   
•
When throttle value is stuck at 5°, engine speed is limited at below 1,500 rpm and vehicle speed at maximum 40 - 50 km/h (25 - 31mph).

    Specification Throttle Angle (°) Output Voltage (V) [Vref = 5V] TPS1 TPS2 0 0 3.

    Schematic Diagram Circuit Diagram [M/T] [A/T] Harness Connector

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Immobilizer Control Unit. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box. (Refer to Body - "Glove Box Housing") 3. Remove the smart key unit (A) after loosening the nuts.

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Components and components location

    Components Location 1. Compressor Components 1. Clutch bolt 2. Disc & Hub assembly 3. Clutch hub spacer 4. Snap ring 5. Pulley 6. Clutch magnetic coil 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0121