| Components Location |

| 1. Shift lever knob & boots 2. Shift lever assembly 3. Shift cable |
4. Manual control lever 5. shift cable retainer 6. Snap pin |
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Pull the knob (A) in the direction of "F" and remove the knob.
Removal 1. Turn OFF ignition switch and then diconnect the battery negative (-) cable. 2. Remove the air cleaner and air duct.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.
Description and Operation Blcok Diagram • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.