Hyundai Venue (QX): Manual Transaxle Control System / Shift Lever. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Manual Transaxle System / Manual Transaxle Control System / Shift Lever. Repair procedures

Removal
1.
Turn OFF ignition switch and disconnect the negative (-) battery cable.
2.
Remove the shift lever knob & boots (A) pull both of it up.

Hyundai Venue. Shift Lever. Repair procedures
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4.
Separate the clip (A) of wiring.

Hyundai Venue. Shift Lever. Repair procedures
5.
Separate the air duct (A) from the both side.

Hyundai Venue. Shift Lever. Repair procedures
6.
Remove the snap pin (A) and then separate the select cable (B).

Hyundai Venue. Shift Lever. Repair procedures
7.
Separate the cable socket (A) from the shift lever, after release the lock.

Hyundai Venue. Shift Lever. Repair procedures
8.
Remove the shift lever.
(1)
Remove the snap pin (A)
(2)
Loosen the bolts and then removing the shift lever (B).
Tightening torque :
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

Hyundai Venue. Shift Lever. Repair procedures
Installation
1.
To install, reverse the removal procedures.
Hyundai Venue. Shift Lever. Repair procedures   
•
New shift lever assembly is mounted in the neutral fixing pin.
After installation, remove the 4th fixing pin.
•
Check operating of lever of transaxle side when operating shift lever after assembly. (1~6,R)
•
If there is sticky feel, adjust the control cable length again.
(Refer to Manual Trnasxle Control System - "Control Cable")

    Components 1. Shift lever knob & boots 2. Shift lever assembly 3. Select cable 4. Shift cable 5. Retainer 6.

    Components 1. Shift lever knob & boots 2. Shift lever assembly 3. Select cable 4. Shift cable 5. Retainer 6.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.

    Hyundai Venue (QX) (2020-2026) Service Manual: Specifications

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0203