Hyundai Venue: Body Side Molding / Rear Wheel Guard. Repair procedures
• |
Put on gloves to prevent hand injuries.
|
• |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
• |
Take care not to scratch the body surface.
|
|
2. |
Loosen the mounting clip and remove the rear wheel guard (A).

|
3. |
To install, reverse removal procedure.
•
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Replacement
•
Put on gloves to prevent hand injuries...
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from the rear hub.
Tightening torque :
107...
This warning light informs the driver the following situations.
-- Forward Collision-Avoidance Assist system malfunction (if equipped)
-- Forward Collision-Avoidance Assist radar blocked (if equipped)
-- Blind-Spot Collision Warning system malfunction (if equipped)
-- Blind-Spot Collision Warning radar blocked (if equipped)
-- Lamp malfunction (if equipped)
-- High Beam Assist malfunction (if equipped)
-- Tire Pressure Monitoring System (TPMS) malfunction (if equipped)
The Master Warning Light illuminates if one or more of the above warning situations
occur...
Categories

1. Instrument cluster
2. Horn
3. Key ignition switch/ Engine Start/Stop button
4. Infotainment system
5. Hazard warning flasher switch
read more