Hyundai Venue (QX): Body Side Molding / Side Sill Molding. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Body Side Molding / Side Sill Molding. Repair procedures

Replacement
Hyundai Venue. Side Sill Molding. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Remove the fender garnish.
(Refer to Fender Garnish)
2.
Remove the quarter garnish.
(Refer to Quarter Garnish)
3.
Using a remover and remove the side sill molding (A).

Hyundai Venue. Side Sill Molding. Repair procedures
4.
To install, reverse removal procedure.
Hyundai Venue. Side Sill Molding. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • Put on gloves to prevent hand injuries.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2025) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Hyundai Venue (QX) (2020-2025) Service Manual: Evaporator Core. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 3. Separate the evaporator temperature sensor connector (A), loosen the mounting screws and remove the eva

    Categories

     
    Copyright © 2025 www.hvenueqx.com - 0.0114