Hyundai Venue (QX): TailGate / Tail Gate Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / TailGate / Tail Gate Assembly. Repair procedures

Replacement
1.
Remove the TailGate trim.
(Refer to tailgate - "Tailgate Trim")
2.
Using a flat-tip screwdriver, lift up slightly the socketclips (A) of both ends on the lifter (B), and thenremove the lifter from the bracket.

Hyundai Venue. Tail Gate Assembly. Repair procedures
3.
Separate the tailgate main wiring (A) from theTailGate.
4.
Separate the nozzle (B).
5.
Loosen the mounting bolts and remove the tailgateassembly (C).
Tightening torque :
21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)

Hyundai Venue. Tail Gate Assembly. Repair procedures
6.
To install, reverse removal procedure.
Hyundai Venue. Tail Gate Assembly. Repair procedures   
•
Make sure the tailgate locks / unlocks and opens /closes properly.
•
Adjust the tailgate alignment.
•
Make sure the connectors are connected in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Tailgate assembly

    Component Location 1. Tailgate trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Troubleshooting

    Diagnosis with Diagnostic tool 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool). The diagnostic system (Diagnostic tool) provides the following information.

    Hyundai Venue (QX) (2020-2026) Service Manual: Rear Corner Radar Unit. Schematic diagrams

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0073