Hyundai Venue: Hydraulic System / Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Hyundai Venue (QX) (2020-2025) Service Manual / Automatic Transaxle System / Hydraulic System / Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
| Specifications |
▷ Control type : Normally low type
|
Shape |
Items |
Specifications |
|
|
Control current (voltage) [mA] |
0 - 850 |
|
Supply pressure [kpa (kgf/cm², psi)] |
539.36 (5.5, 78.23) |
|
|
Control pressure [kpa (kgf/cm², psi)] |
0-519.75 (0-5.3, 0-75.38) |
|
| Internal
resistance(Ω) |
4.8 - 5.4 |
Torque Converter Control Solenoid Valve (T/CON_VFS). Description and operation
Description
•
Torque converter control solenoid valve (T/CON_VFS) is attached to the
valve body.
•
This variable force solenoid valve indirectly controls the hydraulic
pressure inside the torque converter...
Torque Converter Control Solenoid Valve (T/CON_VFS). Components and components
location
Component Location (1)_Valve
Body Cover
1. Valve Body Cover
2. Valve Body Cover Gasket
3. Solenoid Valve Connector
Component Location (2)_Solenoid
Valve
1...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Variable Intake Solenoid (VIS) Valve. Description and operation
Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table)...
Hyundai Venue (QX) (2020-2025) Service Manual: CVVT Oil Control Valve (OCV). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect OCV connector. 3. Measure resistance between OCV terminals 1 and 2. 4. Check that the resistance is within the specification...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Theft-Alarm System
- Rear Combination Light Bulb Replacement
- Smart Key
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com