Hyundai Venue: Crash Pad / Cluster Fascia Panel. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a flat-tip screwdriver and remove the cluster fascia panel (A).

To install, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Components and components location

Components (1) 1. Crash pad lower panel 2. Steering column shroud lower panel 3. Steering column shroud upper panel 4...

Center Fascia Panel. Repair procedures

Replacement • Put on gloves to prevent hand injuries...

Other information:

Hyundai Venue (QX) (2020-2025) Owners Manual: Rear lamp

Type A Type B Rear Room Lamp (): Press this switch to turn the rear room lamp on and off. (1): The room lamp for the rear seats is automatically turned ON for approximately 30 seconds, when a door is opened. The room lamp for the rear seats is automatically turned ON for approximately 15 seconds, when the remote key (smart key) unlocks the doors...

Hyundai Venue (QX) (2020-2025) Service Manual: Muffler. Repair procedures

Removal and Installation [Front Muffler] 1. Remove the engine cover. 2. Disconnect the battery negative terminal. 3. Disconnect the oxygen sensor connector (A)...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.

Hyundai Venue. Air bag collision sensors