Hyundai Venue (QX): Fuel Delivery System / Accelerator Pedal. Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation nuts (A), and then remove the accelerator pedal
module.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Open the fuel filler door and unfasten the filler-neck assembly mounting botl (A).
Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Hyundai Venue (QX) (2020-2026) Service Manual: Troubleshooting
Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Remote Key
- Child-Protector Rear Door Locks
- Operating Door Locks from Outside the Vehicle
- New on site
- Most important about car
