Hyundai Venue: Front Door / Front Door Latch. Repair procedures
• |
When removing with a flat-tip screwdriver or remover,wrap protective
tape around the tools to preventdamage to components.
|
• |
Take care not to scratch the body surface.
|
|
1. |
Remove the front door module.
(Refer to Front Door - "Front Door Module")
|
2. |
Separate the front door outside handle connector (A) and remove the
wiring harness (B).

|
3. |
Remove the front door inside handle case (A) and remove the rubber packing
(B).

|
4. |
Remove the front door latch (A) by gently lifting the locking pin (B).

|
5. |
Open the cover to remove the rod (A) and remove the front door outside
handle base (B).

|
6. |
To install, reverse removal procedure.
•
|
Make sure the connector is connected properly.
|
•
|
Make sure the door locks / unlocks and opens / closes
properly.
|
•
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Other information:
Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent damaging
the heater line. Apply finger pressure on the tin foil, moving the tin
foil along the grid line to check for open circuits...
The Vehicle Stability Management (VSM) is a function of the Electronic Stability
Control (ESC) system. It helps ensure the vehicle stays stable when accelerating
or braking suddenly on wet, slippery and rough roads where traction over the four
tires can suddenly become uneven...
Categories
Vehicle Identification Number (vin)

Frame number
read more