| Component Location |

| 1. Front door outside handle |
Removal 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Cut the heat welds with a knife and remove the front door inside handle (A).
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Component Location [Engine Room] 1. Condenser 2. Discharge hose 3. Suction & Liquid tube assembly 4. Compressor 5. Service port (High pressure) 6. A/C Pressure transducer (APT) 7. Service port (Low pressure) 8.
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.