Hyundai Venue (QX): Body Electrical System / Ignition Switch Assembly
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel.
Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location
Component Location [Engine Room] 1. Condenser 2. Discharge hose 3. Suction & Liquid tube assembly 4. Compressor 5. Service port (High pressure) 6. A/C Pressure transducer (APT) 7. Service port (Low pressure) 8.
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Tire Pressure Monitoring System (TPMS) (Type A)
- Repair procedures
- Liftgate
- New on site
- Most important about car
