| Inspection |
| 1. |
Check for resistance between terminals in each switch position (LH).
[LH : Audio + Hands free]
|
| 2. |
Check for resistance between terminals in each switch position (RH).
[RH : Trip + Cruise]
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
|
| 3. |
Remove the steering lower cover (A).
|
| 4. |
Loosen the steering remote control switch mounting screw.
|
| 5. |
Disconnect the connector (A) and then remove the steering wheel remote
control switch (B).
[RH]
[LH]
|
| Installation |
| 1. |
Install the steering wheel remote control after connecting the connector.
|
| 2. |
Connect the negative (-) battery terminal.
|
Circuit Diagram [Audio] [Audio+Bluetooth] [Audio+Bluetooth+Voice] [Trip] [Trip+Cruise] [Trip+Cruise+SLD]
Circuit Diagram [Compect Audio type] [Display Audio type]
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Replacement 1. Open the glove box. 2. Press both sides of the glove box (A) and take it out. 3. Remove the filter cover (A) by pressing the knob. 4.