Hyundai Venue (QX): SRSCM / Front Impact Sensor (FIS). Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS). Repair procedures

Removal
Hyundai Venue. Front Impact Sensor (FIS). Repair procedures   
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Disconnect the front impact sensor connector (A) and then remove the front impect sensor (B).

Hyundai Venue. Front Impact Sensor (FIS). Repair procedures
Installation
Hyundai Venue. Front Impact Sensor (FIS). Repair procedures   
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Connect the front impact sensor connector.
3.
Install the front impact sensor mounting bolt.
Tightening torque :
6.8 - 7.5 N.m (0.7 - 0.76 kgf.m, 5.0 - 5.5 Ib-ft)
4.
Reconnect the battery negative cable.
5.
After installing the Front Impact Sensor, confirm proper system operation :
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Components 1. Front right Impact Sensor (FIS) 2. Front Left Impact Sensor (FIS)

    Description Side Impact Sensor (SIS) system consists of two SIS which are installed at each center pillar nearby (LH and RH). Side Impact Sensor is also called A-SIS because it detects acceleration.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Repair procedures

    Removal    Precautions for using the plastic pulley • Be careful not to place the pulley to downwards of the floor or table.

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0121