Hyundai Venue (QX): Front Suspension System / Front Lower Arm. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Suspension System / Front Suspension System / Front Lower Arm. Repair procedures

Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
Hyundai Venue. Front Lower Arm. Repair procedures   
•
Be careful not to damage the hub bolts when removing the front wheel and tire (A).

Hyundai Venue. Front Lower Arm. Repair procedures
3.
Loosen the lower arm nut (A) and then remove the lower arm ball joint by using SST(09568-1S100).
Tightening torque :
68.6 - 80.4 N.m (7.0 - 8.2 kgf.m, 50.6 - 59.3 lb-ft)

Hyundai Venue. Front Lower Arm. Repair procedures

Hyundai Venue. Front Lower Arm. Repair procedures
4.
Remove the front lower arm (A) after loosening the bolts & nuts.
Tightening torque
Front : 127.5 - 147.1 N.m (13.0 - 15.0 kgf.m, 94.0 - 108.5 lb-ft)
Rear : 156.9 - 176.5 N.m (16.0 - 18.0 kgf.m, 115.7 - 130.2 lb-ft)

Hyundai Venue. Front Lower Arm. Repair procedures
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the lower arm for deformation.
3.
Check the all bolts and nuts.
Installation
1.
Install in the reverse order of removal.
2.
Check the wheel alignment.
(Refer to Tires / Wheels - "Alignment")

    Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.

    Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Description and operation

    Description The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of heater core. The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in highly effective diesel engine.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0191