Hyundai Venue (QX): Fuel Delivery System / Fuel Pump. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump. Repair procedures

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
3.
Remove the rear seat.
(Refer to Body - "Rear Seat Assembly")
4.
Remove the fuel pump service cover (A).

Hyundai Venue. Fuel Pump. Repair procedures
5.
Disconnect the fuel pump connector (A).

Hyundai Venue. Fuel Pump. Repair procedures
6.
Disconnect the fuel feed tube quick-connector (A).
7.
Disconnect the ventilation hose (B).
8.
Disconnect the vapor hose quick-connector (C).

Hyundai Venue. Fuel Pump. Repair procedures
9.
Remove the locking ring (A) by using the SST [SST No : 09310-B8100] from the fuel tank.
Hyundai Venue. Fuel Pump. Repair procedures   
•
When removing the plate cover, be careful not to damage the fuel tank and fuel pump.
•
When removing the plate cover, press the upper area with hand and rotate the wrench counter clockwise.

Hyundai Venue. Fuel Pump. Repair procedures
10.
Remove the fuel pump from the fuel tank.

Hyundai Venue. Fuel Pump. Repair procedures
Installation
1.
Install in the reverse order of removal.
Hyundai Venue. Fuel Pump. Repair procedures   
•
Be careful of fuel pump direction when installing. (Refer to the groove in the fuel tank)

    Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2.

    Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).

    Other information:

    Hyundai Venue (QX) (2020-2025) Service Manual: Condenser. Components and components location

    Hyundai Venue (QX) (2020-2025) Service Manual: Blower Unit. Components and components location

    Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.

    Categories

     
    Copyright © 2025 www.hvenueqx.com - 0.0124