Hyundai Venue (QX): Fuel Delivery System / Fuel Tank. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Tank. Repair procedures

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
3.
Remove the rear seat.
(Refer to Body - "Rear Seat Assembly")
4.
Remove the fuel pump service cover (A).

Hyundai Venue. Fuel Tank. Repair procedures
5.
Disconnect the fuel pump connector (A).

Hyundai Venue. Fuel Tank. Repair procedures
6.
Disconnect the fuel feed tube quick-connector (A).
7.
Disconnect the ventilation hose (B).
8.
Disconnect the vapor hose quick-connector (C).

Hyundai Venue. Fuel Tank. Repair procedures
9.
Lift the vehicle.
10.
Disconnect the Leveling hose quick-connector (A).
11.
Disconnect the fuel filler hose (B).

Hyundai Venue. Fuel Tank. Repair procedures
12.
Remove the side under cover (A).

Hyundai Venue. Fuel Tank. Repair procedures
13.
Remove the brake line (A) bracket mounting bolts (B).

Hyundai Venue. Fuel Tank. Repair procedures
14.
Support the fuel tank with jack (A).
15.
Remove the fuel tank installation nut (B) and then loosen the fuel tank.
Fuel tank band installation nut :
39.2 - 54.0 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

Hyundai Venue. Fuel Tank. Repair procedures
Installation
1.
Install in the reverse order of removal.

    Release Residual Pressure in Fuel Line    • There may be some residual pressure even after "Release Residual Pressure in Fuel Line" work, so cover the hose connection with a shop towel to prevent residual fuel from spilling out before disconnecting any fuel connection.

    Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Components and components location

    Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0119