| Replacement |
| 1. |
Remove the hood weatherstrip (A).
|
| 2. |
To install, reverse removal procedure.
|
Replacement 1. Using a clip remover, remove the clips and then the hood insulator pad (A). • Be careful not to scratch the hood panel.
Component Location 1. Hood latch release handle
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.