| Description |
| • |
The inhibitor switch mounted on the upper of transaxle and connected
with shifter lever.
|
| • |
The inhibitor switch has four points of contact and it makes the signals(S1,
S2, S3, S4).
|
| • |
The inhibitor switch signals delivered at the TCM according to control
of the shift lever positions(P, R, N, D) and it is used to control of
the gear setting.
|
Removal • When Diagnostic Trouble Codes (DTC) is on, perform the following procedure to replace it.
Specifications â–· Type : Combination of output signals from 4 terminals â–· Specifications Items Specifications Power supply (V) 12 Output type Combination of output signals
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box. (Refer to Body - "Glove Box Housing") 3. Remove the smart key unit (A) after loosening the nuts.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.