Hyundai Venue (QX): Engine Control System / Knock Sensor (KS). Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS). Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the knock sensor connector.
3.
Measure resistance between the CKPS terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification : Approximately. 4.87 MΩ [20°C (68°F)]
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the knock sensor connector (A).

Hyundai Venue. Knock Sensor (KS). Repair procedures
3.
Remove the engine room under cover
(Refer to Engine Mechanical System - "Engine Room Under Cover")
4.
Remove the mounting bolt (A), and then remove the sensor from the cylinder block.
Knock sensor installation bolt :
18.6 - 24.5 N.m (1.9 - 2.5 kgf.m, 13.7 - 18.1 lb-ft)

Hyundai Venue. Knock Sensor (KS). Repair procedures
Installation
Hyundai Venue. Knock Sensor (KS). Repair procedures   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Install in the reverse order of removal.

    Circuit Diagram [M/T] [A/T] Harness Connector

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: General safety information and caution

    Instructions (R-134a) When Handling Refrigerant 1. R-134a liquid refrigerant is highly volatile. A drop on the skin of your hand could result in localized frostbite. When handling the refrigerant, be sure to wear gloves.

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (DATC). Repair procedures

    Self Diagnosis 1. Self-diagnosis process.    • When operating the self-diagnostics, the below fault(self-diagnostics code) will blink at 0.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0155