Hyundai Venue (QX): Power Door Locks / Power Door Lock Switch. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch. Repair procedures

Diagnosis with GDS
1.
In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool).
The diagnostic system(Diagnostic tool) provides the following information.
(1)
The diagnostic system(Diagnostic tool) provides the following information.
(2)
Data Analysis : Checking the system input/output data state.
(3)
Actuation test : Checking the system operation condition.
(4)
S/W Management : Controlling other features including system option setting and zero point adjustment
2.
If diagnose the vehicle by GDS, select "DTC Analysis" and "Vehicle".

Hyundai Venue. Power Door Lock Switch. Repair procedures
3.
If check current status, select the "Data Analysis" and "Car model".

Hyundai Venue. Power Door Lock Switch. Repair procedures
4.
Select the 'ICU' to search the current state of the input/output data.

Hyundai Venue. Power Door Lock Switch. Repair procedures

Hyundai Venue. Power Door Lock Switch. Repair procedures
5.
To forcibly actuate the input value of the module to be checked, select option 'Actuation Test'.

Hyundai Venue. Power Door Lock Switch. Repair procedures
Removal
Driver Power Window Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Remove the power window switch assembly (A) by pulling out both ends of the switch holders.

Hyundai Venue. Power Door Lock Switch. Repair procedures
Installation
Driver Power Window Switch
1.
Install the power window switch assembly.
2.
Install the front door trim after connect the connector.

    Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Components and components location

    Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0143