Hyundai Venue (QX): Power Door Locks / Power Door Lock Actuators. Repair procedures
| Inspection |
| 1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 2. |
Remove the front door module.
(Refer to Body - "Front Door Module")
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
| 1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
| 2. |
Remove the rear latch.
(Refer to Body - "Rear Door Latch")
|
| 3. |
Disconnect the connectors from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
| 1. |
Remove the door switch (A) after loosening the screw and disconnecting
the connector (B).
|
| 2. |
Check for continuity between the terminals in each switch position according
to the table.
|
| 1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
| 2. |
Disconnect the connector from the actuator.
|
| 3. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
| 1. |
Disconnect the connector (A) and bolts from the hood switch.
|
| 2. |
Check for continuity between the terminals and ground according to the
table.
|
Component Location 1. Driver power window main switch 2. Assist power window main switch 3. ICU junction block 4. Door lock knob 5.
Diagnosis with GDS 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool).
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures
Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3.
Hyundai Venue (QX) (2020-2026) Service Manual: Photo Sensor. Description and operation
Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received which is transferred to th
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Convenient Features
- Front Suspension System
- Tire Pressure Monitoring System (TPMS) (Type A)
- New on site
- Most important about car
