Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel.
Component Location 1. Driver power window main switch 2. Assist power window main switch 3. ICU junction block 4. Door lock knob 5.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.