| Description |

Inspection 1. Turn ignition switch OFF. 2. Disconnect injector connector. 3.
Specification Item Specification Coil Resistance (Ω) 18.5 - 22.5 [23°C (73.4°F)]
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Removal 1. Remove the bumper cover. (Refer to Body - "Front Bumper Cover") 2. Disconnect the connector (A) from the PDW sensor. [L - Type] Installation 1.