| Inspection |
| 1. |
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (Diagnostic tool).
The diagnostic system(Diagnostic tool) provides the following information.
|
| 2. |
If diagnose the vehicle by GDS, select "DTC Analysis" and "Vehicle".
|
| 3. |
If check current status, select the "Data Analysis" and "Car model".
|
| 4. |
Select the 'ICU' to search the current state of the input/output data.
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the audio unit or the AVN head unit.
(Refer to Audio - "Audio Unit")
(Refer to AVN system - "AVN Head Unit")
|
| 3. |
Remove the heater and A/C controll unit.
(Refer to Heating,Ventilation, Air Conditioning - "Heater & A/C Control
Unit (Manual)")
(Refer to Heating, Ventilation, Air conditioning - "Heater & A/C Control
Unit (DATC)")
|
| Installation |
| 1. |
Install the heater and A/C control unit.
|
| 2. |
Install the audio unit or the AVN head unit.
|
| 3. |
Connect the negative (-) battery terminal.
|
Inspection Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shroud panel.
Removal lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.