Hyundai Venue (QX): Automatic Transaxle Control System / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Automatic Transaxle System\ / Automatic Transaxle Control System / Repair procedures

Adjustment
TCM Learning
1.
Overview and purpose of learning
1)
The purpose is to ensure the initial operation safety by correcting the oil pressure differences between transmissions.
2)
For relearning of TCM, process relearning by deleting existing contents using diagnostic tool when there is shift shock at gears 1-2-3-4-5-6-7-8.
2.
In the following case, TCM learning is required.
1)
Automatic transaxle assembly replacement
2)
TCM replacement
3)
TCM upgrade
3.
TCM learning procedure
1)
Condition : ATF temperature 35 - 95°C (95 - 203°F)
2)
Stop learning
- Repeat the shift pattern shown below five times or more with the brake stepped on.

Hyundai Venue. Repair procedures
3)
Driving relearn
- Maintain the throttle open to a constant level with the gear in D position and increment from 1st to 5th gear within 1500 ~ 2500 RPM of engine and decelerate slowly.
With (ON, throttle opening: 0%), decrement from 8th to 1st gear.
- Upshift throttle opening : 15 - 35% (a proper value for making upshift within 1500 - 2500RPM of engine)

Hyundai Venue. Repair procedures

    Description • Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values.

    Description • Monitors the vehicle's operating conditions to determine the optimal gear setting. • Performs a gear change if the current gear setting differs from the identified optimal gear setting.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0189