| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the overhead console lamp lense (A).
|
| 3. |
Remove the over head console lamp and disconnect the switch (A) and
map lamp connectors.
|
| 4. |
Check for continuity between the terminals.
|
Circuit Diagram
Inspection 1. Disconnect the negative battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3.
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Description and Operation Blcok Diagram • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.