Hyundai Venue: Interior Trim / Rear Transverse Trim. Components and components location

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Transverse Trim. Components and components location

Component Location

Hyundai Venue. Rear Transverse Trim. Components and components location

1. Rear transverse trim

Center Pillar Trim. Repair procedures

Replacement [Center pillar lower trim] • Put on gloves to prevent hand injuries...

Rear Transverse Trim. Repair procedures

Replacement • Put on gloves to prevent hand injuries...

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: Specifications

Specifications Item Specification Clutch operation method Hydraulic type Clutch cover assembly Type Diaphragm spring strap Clutch disc Type Single dry with diaphragm Facing diameter (Outer × inner) Ø210 ± 1 × Ø140 ± 1(Ø8...

Hyundai Venue (QX) (2020-2025) Service Manual: Rear Door Inside Handle. Repair procedures

Removal 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Cut the heat welds with a knife and remove the front door inside handle (A). • Cut the heat welds with a knife, paying attention to damage...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.

Hyundai Venue. Air bag collision sensors