Hyundai Venue: Body (Interior and Exterior) / Interior Trim
Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Interior Trim
- Components and components location
- Door Scuff Trim. Components and components location
- Door Scuff Trim. Repair procedures
- Cowl Side Trim. Components and components location
- Cowl Side Trim. Repair procedures
- Front Pillar Trim. Components and components location
- Front Pillar Trim. Repair procedures
- Center Pillar Trim. Components and components location
- Center Pillar Trim. Repair procedures
- Rear Transverse Trim. Components and components location
- Rear Transverse Trim. Repair procedures
- Luggage Side Trim. Components and components location
- Luggage Side Trim. Repair procedures
- Rear Pillar Trim. Components and components location
- Rear Pillar Trim. Repair procedures
Roof Trim Assembly. Repair procedures
Replacement
•
Put on gloves to prevent hand injuries...
Components and components location
Components
1. Front pillar trim
2. Front door scuff trim
3. Center pillar upper trim
4. Rear pillar trim
5...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: CVVT (Continuously Variable Valve Timing) System. Description and operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which makes better fuel economy and reduces exhaust gases (NOx, HC) and improves engine performance through reduction of pumping loss, internal EGR effect, improvement of combustion stability, improvement of volumetric efficiency, and increase of expansion work...
Hyundai Venue (QX) (2020-2025) Service Manual: Audio Remote Control. Repair procedures
Inspection 1. Check for resistance between terminals in each switch position (LH). [LH : Audio + Hands free] Switch Connector terminal Resistance (±5%) SEEK Up 1 - 6 430Ω SEEK Down 1...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Liftgate
- Theft-Alarm System
- Warning and Indicator Lights
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com