Hyundai Venue: Ignition Coil / Repair procedures
1. |
Disconnect the battery nagative terminal.
|
2. |
Remove the engine cover.
|
3. |
Disconnect the ignition coil connectors (A).

•
|
When removing the ignition coil connector, pull the
lock pin (A) and push the clip (B).

|
|
|
4. |
Remove the ignition coil (A).
Ignition coil installation bolts :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 Ib-ft)
|

|
1. |
Install in the reverse order of removal.
|
1. |
Measure the primary coil resistance between terminals (+) and (-).

Standard value : 0.75Ω ± 15%
|
|
Description
A spark plug is a device for delivering electric current from an ignition system
to the combustion chamber of a spark-ignition engine to ignite the compressed
fuel/air mixture therein by means of an electric spark, while containing combustion
pressure within the engine...
Other information:
The rear corner radars are located inside the rear bumper for detecting the side
and rear areas. Always keep the rear bumper clean for proper operation of the system.
NOTICE
The system may not work properly when the bumper has been damaged, or
if the rear bumper has been replaced or repaired...
Tire Wear
•
Using tires and wheel other than the recommended sizes could
cause unusual handling characteristics and poor vehicle control,
resulting in a serious accident...
Categories

This gauge indicates the approximate amount of fuel remaining in the fuel tank.
Information
The fuel tank capacity is given in chapter 2.
The fuel gauge is supplemented by a low fuel warning light, which will
illuminate when the fuel tank is nearly empty.
On inclines or curves, the fuel gauge pointer may fluctuate or the low
fuel warning light may come on earlier than usual due to the movement of fuel
in the tank.
read more