Hyundai Venue: Body Side Molding / Roof Side Molding. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

•	Install roof molding before wind shield glass & rear glass.

1.	Using a flat-tip screwdriver and remove the rood roof side molding assembly (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Side Sill Molding. Repair procedures

Replacement • Put on gloves to prevent hand injuries...

Roof Rack. Components and components location

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: Heater & A/C Control Unit (Manual). Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper front garnish. (Refer to Floor Console - "Floor Console Assembly") 3...

Hyundai Venue (QX) (2020-2025) Owners Manual: Interior Care

Interior general precautions Prevent caustic solutions such as perfume and cosmetic oil, from contacting the interior parts because they may cause damage or discoloration. If they do contact the interior parts, wipe them off immediately. See the instructions for the proper way to clean vinyl...

Categories

Fuel gauge

Hyundai Venue. Fuel gauge

This gauge indicates the approximate amount of fuel remaining in the fuel tank.

Information

The fuel tank capacity is given in chapter 2. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On inclines or curves, the fuel gauge pointer may fluctuate or the low fuel warning light may come on earlier than usual due to the movement of fuel in the tank.