Hyundai Venue (QX): Automatic Transaxle Control System / Shift Cable. Components and components location
Hyundai Venue (QX) (2020-2026) Service Manual / Automatic Transaxle System\ / Automatic Transaxle Control System / Shift Cable. Components and components location
| Components Location |
| 1. Shift lever knob & boots 2. Shift lever assembly 3. Shift cable |
4. Manual control lever 5. shift cable retainer 6. Snap pin |
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Pull the knob (A) in the direction of "F" and remove the knob.
Removal 1. Turn OFF ignition switch and then diconnect the battery negative (-) cable. 2. Remove the air cleaner and air duct.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Hyundai Venue (QX) (2020-2026) Service Manual: Mode Control Actuator. Components and components location
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Brake System
- Remote Key
- Electronic Stability Control (ESC)
- New on site
- Most important about car
Copyright В© 2026 www.hvenueqx.com - 0.0179