Hyundai Venue: Automatic Transaxle System / Automatic Transaxle Control System
Hyundai Venue (QX) (2020-2025) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System
- Description and operation
- Repair procedures
- Transaxle Control Module (TCM). Description and operation
- Transaxle Control Module (TCM). Schematic diagrams
- Transaxle Control Module (TCM). Repair procedures
- Transaxle Oil Temperature Sensor. Description and operation
- Transaxle Oil Temperature Sensor. Specifications
- Transaxle Oil Temperature Sensor. Repair procedures
- Input Speed Sensor. Description and operation
- Input Speed Sensor. Specifications
- Input Speed Sensor. Repair procedures
- Output Speed Sensor. Description and operation
- Output Speed Sensor. Specifications
- Output Speed Sensor. Repair procedures
- Inhibitor Switch. Description and operation
- Inhibitor Switch. Specifications
- Inhibitor Switch. Troubleshooting
- Inhibitor Switch. Repair procedures
- Shift Lever. Components and components location
- Shift Lever. Repair procedures
- Shift Cable. Components and components location
- Shift Cable. Repair procedures
Oil Cooler. Repair procedures
Repair procedures
•
ATF cooler is a unit with the radiator, so refer to radiator
removal/installation procedures in the engine section...
Description and operation
Description
•
Automatic transaxle system relies on various measurement data to determine
the current control status and extrapolate the necessary compensation
values...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Condenser. Repair procedures
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2...
Hyundai Venue (QX) (2020-2025) Service Manual: Drive Belt. Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Loosen the mounting bolts (A) and then, turn the adjusting bolt (B) clockwise in loose tension. 3. Remove the drive belt (A)...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Electronic Stability Control (ESC)
- Trip Computer
- Child-Protector Rear Door Locks
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com