Hyundai Venue: Driveshaft and axle / Troubleshooting

Hyundai Venue (QX) (2020-2025) Service Manual / Driveshaft and axle / Troubleshooting

Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel bearing
Replace
Defective front suspension and steering
Adjustment or Replace
Vibartion
Wear, damage or bending of driveshaft
Replace
Driveshaft rattle and hub serration
Replace
Wear, rattle or scratching of wheel bearing
Replace
Shimmy
Defective wheel balance
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace
Excessive noise
Wear, damage or bending of driveshaft
Replace
Rattle of driveshaft and worn hub splines
Replace
Wear, rattle or scoring of wheel bearing
Replace
Loose hub nut
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace

    Special service tools

    ..

    Front Hub / Knuckle

    ..

    Other information:

    Hyundai Venue (QX) (2020-2025) Owners Manual: Jack and Tools


    (1) Jack handle (2) Jack (3) Wheel lug nut wrench (4) Towing hook The jack, jack handle, and wheel lug nut wrench are stored in the luggage compartment under the luggage box cover. The jack is provided for emergency tire changing only. Turn the winged hold down bolt counterclockwise to remove the spare tire...

    Hyundai Venue (QX) (2020-2025) Service Manual: Camshaft Position Sensor (CMPS). Repair procedures


    Inspection 1. Check signal waveform of CKPS and CMPS using a scan tool. Specification : Refer to "Waveform" Removal    • DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine oil may occur...

    Categories

    Vehicle Identification Number (vin), Vehicle Certification Label

    Vehicle Identification Number (vin)

    Hyundai Venue. Vehicle Identification Number (vin), Vehicle Certification Label

    Frame number

    read more


     
    Copyright © 2025 www.hvenueqx.com