Hyundai Venue (QX): Engine Control System / Heated Oxygen Sensor (HO2S)

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the knock sensor connector. 3.

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed on upstream and downstream of the Warm up Catalytic Converter (WCC).

Other information:

Hyundai Venue (QX) (2020-2026) Service Manual: Receiver-Drier. Repair procedures

Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.

Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

Categories

 
Copyright В© 2026 www.hvenueqx.com - 0.013