| Replacement |
| 1. |
Using a clip remover, remove the clips and then the hood insulator pad
(A).
|
| 2. |
To install, reverse removal procedure.
|
Replacement • Be careful not to damage the hood and body.
Replacement 1. Remove the hood weatherstrip (A). • Be careful not to scratch the hood weatherstrip.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.