| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
|
| 3. |
Disconnect the ignition lock & clutch switch connector (A).
|
| 4. |
Separate the push rod (A).
|
| 5. |
Remove the clutch pedal assembly (A) after loosening the bolts (B).
|
| Installation |
| 1. |
To install, reverse the removal procedures.
|
Components 1. Clutch pedal assembly 2. Clutch pedal arm 3. Ignition lock & clutch switch 4. Clutch master cylinder 5.
Components 1. Clutch pedal assembly 2. Clutch pedal arm 3. Ignition lock & clutch switch 4. Clutch master cylinder 5.
Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.