| Components |

| 1. Pulley 2. Front housing 3. Front bearing 4. Stator 5. Rotor |
6. Rear
bearing 7. Rear housing 8. Rectifier assembly 9. Regulator assembly 10. Rear cover |
Specification Alternator Item Specification Rated voltage 13.5V, 120A Speed in use 1,000 - 18,000 rpm Voltage regulator IC Regulator built-in type Regulator Setting Voltage External mode Refer to below graph Internal mode 14.
Removal 1. Turn ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the drive belt.
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.