Hyundai Venue (QX): Alternator / Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Electrical System / Charging System / Alternator / Description and operation

Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.

Hyundai Venue. Description and operation

1. Brush
2. OAP
3. Rotor
4. Stator
5. Rectifier

    Specification Alternator Item Specification Rated voltage 13.5V, 120A Speed in use 1,000 - 18,000 rpm Voltage regulator IC Regulator built-in type Regulator Setting Voltage External mode Refer to below graph Internal mode 14.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location

    Component Location [Engine Room] 1. Condenser 2. Discharge hose 3. Suction & Liquid tube assembly 4. Compressor 5. Service port (High pressure) 6. A/C Pressure transducer (APT) 7. Service port (Low pressure) 8.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0165