Hyundai Venue (QX): Automatic Transaxle Control System / Output Speed Sensor. Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Automatic Transaxle System\ / Automatic Transaxle Control System / Output Speed Sensor. Description and operation

Description
The output speed sensor is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the TCM. The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

Hyundai Venue. Output Speed Sensor. Description and operation

    Removal    • When Diagnostic Trouble Codes (DTC) is on, perform the following procedure to replace it.

    Specifications ▷ Type : Hall effect sensor ▷ Specifications Items Specifications Operation condition [°C(°F)] (-40 to 150) -40 to 302 Output voltage(V) High 1.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Refrigerant Line. Repair procedures

    Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0116