Hyundai Venue (QX): Lighting System / Overhead Console Lamp. Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the overhead console lamp lense (A).
|
| 3. |
Remove the mounting screws and then remove the overhead console (A).
|
| 4. |
Remove the overhead console after disconnect the connector (A).
|
| Installation |
| 1. |
Install the overhead console lamp after connecting the connector.
|
| 2. |
Install the lens after tightening 2 screws.
|
Removal [Room Lamp] 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, Separate the room lamp lens (A) from the room lamp.
REMOVAL Front Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Disconnect the turn signal lamp connector (A).
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Instrument Cluster
- Tire Pressure Monitoring System (TPMS) (Type A)
- Repair procedures
- New on site
- Most important about car
