Hyundai Venue (QX): Ignition Lock Switch / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Clutch System / Ignition Lock Switch / Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
3.
Disconnect the ignition lock & clutch switch connector (A).

Hyundai Venue. Repair procedures
4.
Remove the ignition lock & clutch switch (A) after loosening the bolts (B).

Hyundai Venue. Repair procedures

Hyundai Venue. Repair procedures
Inspection
Component Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the ignition lock & clutch switch.
3.
Rotate the switch lever to the direction of the arrow to check the operating point (A).

Hyundai Venue. Repair procedures

Hyundai Venue. Repair procedures
Installation
1.
Install is proceeds as follows.
※ How to install the ignition lock & clutch switch
(A) After inserting the switch lever (A) into the clutch pedal pin (B), pre-tighten the switch mounting bolts (C).
(B) Set the clutch switches so as to confirm that the electric current is applied to the pins â‘  and â‘¢.
(C) Fix the clutch pedal to the ignition lock switch OFF→ON strokes (F).
(D) With the pedal fixed, rotate the switch clockwise and counter-clockwise to set it to a position at the transition from OFF to ON. Then, tighten the mounting bolts (C) to the specified torque.
(E) Once completing the assembly, check again that the switch is correctly operating.
※ OFF→ON stroke tolerance should be within ± 7.7 mm (0.3031 in.)
OFF → ON Position (F) :
121.8 ± 7.7 mm (4.7953 ± 0.3031 in.)
Tightening torque :
2.0 - 3.9 N.m (0.2 - 0.4 kgf.m, 1.4 - 2.9 lb-ft)

Hyundai Venue. Repair procedures

    Description – Ignition lock switch is mounted on the clutch pedal. – Ignition lock switch is operated when you press the clutch pedal.

    Specifications Item Specifications Working voltage DC 12.5V ± 0.3V Operating force Initial position : 0.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station. 3. When the engine is cool, drain the engine coolant from the radiator.

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (Manual). Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper front garnish. (Refer to Floor Console - "Floor Console Assembly") 3.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0277