Hyundai Venue: ESP(Electronic Stability Program) System / Rear Wheel Speed Sensor. Components and components location
Hyundai Venue (QX) (2020-2025) Service Manual / Brake System / ESP(Electronic Stability Program) System / Rear Wheel Speed Sensor. Components and components location
| Components |
| 1. Rear wheel speed sensor connector |
2. Rear wheel speed sensor |
Front Wheel Speed Sensor. Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2...
Rear Wheel Speed Sensor. Repair procedures
Removal
[Rear Drum Brake Type]
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Ambient Temperature Sensor. Description and operation
Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature...
Hyundai Venue (QX) (2020-2025) Service Manual: Description and operation
Description The Tire Pressure Monitoring System (TPMS) monitors the pressure and temperature inside the tire in order to warn the driver of changes in pressure which may influence the operation of the vehicle. The TPMS control module analyzes wireless information fro In other words, the system detects the pneumatic pressure of the tires and warns the driver of if the pneumatic pressure drops below the standard level...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Check Tire Pressure
- Immobilizer System
- Trip Computer
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com