Hyundai Venue (QX): Ignition Lock Switch / Clutch Switch. Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
|
| 3. |
Disconnect the ignition lock & clutch switch connector (A).
|
| 4. |
Remove the ignition lock & clutch switch (A) after loosening the bolts
(B).
|
| Inspection |
| Component Inspection |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Remove the ignition lock & clutch switch.
|
| 3. |
Rotate the switch lever to the direction of the arrow to check the operating
point (A).
|
| Installation |
| 1. |
Install is proceeds as follows.
※ How to install the ignition lock & clutch switch
(A) After inserting the switch lever (A) into the clutch pedal pin (B),
pre-tighten the switch mounting bolts (C).
(B) Set the clutch switches so as to confirm that the electric current
is applied to the pins â‘¡ and â‘£.
(C) Fix the clutch pedal to the ignition lock switch ON→OFF strokes
(F).
(D) With the pedal fixed, rotate the switch clockwise and counter-clockwise
to set it to a position at the transition from ON to OFF. Then, tighten
the mounting bolts (C) to the specified torque.
(E) Once completing the assembly, check again that the switch is correctly
operating.
※ ON→OFF stroke tolerance should be within ± 3 mm (0.1181 in.)
|
Description – Clutch operation is detected through clutch switch signal. This signal enables ECM to cope with instant change of load condition.
Components 1. Clutch pedal assembly 2. Clutch pedal arm 3. Ignition lock & clutch switch 4. Clutch master cylinder 5.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (DATC). Repair procedures
Self Diagnosis 1. Self-diagnosis process. • When operating the self-diagnostics, the below fault(self-diagnostics code) will blink at 0.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Shift-lock system, Shift-lock release, Parking
- Electronic Stability Control (ESC)
- Instrument Cluster
- New on site
- Most important about car
