Hyundai Venue: Body Electrical System / Rear Wiper/Washer

Hyundai Venue (QX) (2020-2025) Service Manual / Body Electrical System / Rear Wiper/Washer

Front Washer Motor. Repair procedures

Inspection Front and Rear Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water...

Components and components location

Component Location 1. Rear wiper arm nut 2. Rear wiper arm & blade 3. Rear wiper motor assembly 3. Rear wiper motor assembly nut 5...

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: Oil Pan. Repair procedures

Removal 1. Disconnect the battery negative terminal. 2. Remove the engine room under cover. 3. Drain the engine oil. (Refer to Lubrication System - "Engine Oil") 4...

Hyundai Venue (QX) (2020-2025) Service Manual: Camshaft Position Sensor (CMPS). Repair procedures

Inspection 1. Check signal waveform of CKPS and CMPS using a scan tool. Specification : Refer to "Waveform" Removal • DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine oil may occur...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.

Hyundai Venue. Air bag collision sensors