Removal and Installation 1. Remove the oil level gauge & rod (A). Tightening torque : 9.
Removal and Installation 1. Remove the engine cover. (Refer to Engine and Transaxle Assembly - "Engine Cover") 2.
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 3. Separate the evaporator temperature sensor connector (A), loosen the mounting screws and remove the eva
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.