Hyundai Venue: Body (Interior and Exterior) / Hood
Replacement
•
When removing the fender, wrap protective tape around a screwdriver
or remover not to damage components
•
Put on gloves to prevent hand injuries
•
When removing the clips, use a clip remover...
Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) by
moving it up and down or from side to side and tighten the bolt...
Other information:
Component Location
1. Heater unit assembly
Compoents
1. Mode control actuator
2. Heater core case
3. Center duct seal
4. PTC heater
5. Heater core assembly
6. Heater case [LH]
7...
Component Location (1)_Valve
Body Cover
1. Valve Body Cover
2. Valve Body Cover Gasket
3. Solenoid Valve Connector
Component Location (2)_Solenoid
Valve
1. 26 Brake Control Solenoid
Valve
2...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air bags
or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If the location
or angle of the sensors is altered, the air bags may deploy when they should
not or may not deploy when they should.
Do not install bumper guards or replace the bumper with a nongenuine
HYUNDAI parts. This may adversely affect the collision and air bag deployment
performance.
Place the ignition switch in the LOCK/OFF or ACC position when the vehicle
is being towed to prevent inadvertent air bag deployment.
Have all air bag repairs conducted by an authorized HYUNDAI dealer.

read more